Making Skin Beautiful

From Tutiki

by Gordon Eyre

Let me start this tutorial by stating the obvious, not everyone has beautiful skin. To compound this problem we have skin eruptions, uneven tan, freckles, unwanted highlights, large pores, etc. In addition, today’s cameras and lenses magnify every imperfection and freeze it for all to see. This tutorial will help the photographer put their models in the best light so to speak. I will start at the point where you have completed your basic processing and have an image with the correct exposure value and white balance.

Overview

This subject will be covered in steps as follows:

1. Removing or softening major flaws in the skin
2. Touching up undesired reflections and highlights
3. Apply a Gaussian blur to the skin to soften and blend it.
4. Spot sharpening

Note for MAC users: Substitute the Option key for the Alt key when specified in the tutorial.

Removing or softening flaws

There are many ways to remove flaws from the skin; however, I like to use the clone tool. I do not use the clone tool to remove and replace the skin but rather in a special way that will allow me to work slowly to hide the flaw or blemish on the skin. The beautiful young lady pictured here is typical of teenagers in that hormones may cause zits or other eruptions on their skin that are unsightly. As a photographer it is our job to lessen that and make the model look their best. You will note on the neck of this young lady a rather large skin eruption. This is not a normal mark and one that I am sure she wishes were not there.

[msb01.jpg+]

On the tool bar on the left hand side of the workspace is the clone tool. Click on this tool. Now go to the mode setting at the top and select a soft brush that is near to or smaller than the blemish. Move to the right and click on mode, setting it to lighten. Move to the right and set the opacity to